Catch-pots and Ancillaries


FT Pipeline Systems offers catch-pots for all of our dual containment systems. The standard catch-pot is 450mm x 350mm x 300mm high with a 50mm flange for mounting. This can also be attached on the side of the catch-pot so you can mount it on a wall. Please note, this is the standard size but any size can be manufactured to suit your application.

The catch-pot is made of 9mm Polypropylene and has a removable clear lid secured with stainless steel screws. The lid is sealed with an EPDM gasket for an all-round watertight finish and the hose is connected by our bespoke range of fittings to an isolation valve from GF with a lockable handle.

Entry and exit for the DC Hose is by using our special tank connectors with a compression weather seal for sizes up to 32mm DC Hose and then a special boss is made to suit the 38mm and 50mm DC Hose using an O-ring for weather sealing. There is access in the top for a level sensor (Hawker E14 usually supplied) and a connection in the base for a ½” GF lockable handle drain valve.

Spray Shields

Safety Spray Shields are used to prevent injury to personnel or damage to equipment in the event of a leak or spray-out of acids, caustics, chlorine, and other dangerous liquids at piping connections found in chemical, pulp/paper, petrochemical and wastewater treatment plants. Our Safety Spray Shields are constructed from PTFE, polypropylene, PVC, polyethylene, and stainless steel and offer an extra level of protection to hose connections.

Hose Shield

Hose Shield

Transfer Line Shield

Transfer Line Sleeve

Download the Spray Shields Datasheet

Additional Hose Accessories

Please email or call the office on 01543 416024 if you would like to receive a copy of our Water Treatment Technical Book.


FT Pipeline Systems Ltd
6B Eastern Park
Eastern Avenue
WS13 7SY

Tel: 01543 416024

Terms & Conditions

© FT Pipeline Systems Ltd